Clarke Vantage 14 Service Manual download pdf (Page 15)

INSTRUCTIONS FOR USE ENGLISH

9099650000 - VANTAGE 17 B 13

BEFORE MACHINE START-UP

Brush or pad-holder installation

NOTE

Use either the brush (54) or the pad-holder (55 and 56) according to the type of oor to be cleaned.

1. Insert the positioning pin (24) and disengage the machine transport/parking device (23b).

2. Lift the brush/pad-holder deck (10) by prying the handlebar (2).

3. Place the brush (54) or the pad-holder (55 and 56) under the deck.

4. Lower the deck (10) by using the handlebar (2).

5. Turn the switch (62) to “I”.

6. Press the brush enabling push-buttons (61) to engage the brush/pad-holder to the deck hub (10). If necessary, repeat the

procedure until the brush/pad-holder is engaged.

Available brushes and their relevant application guides (suggestions only)

Models MIDLITE GRIT 180 MIDGRIT 240 PROLITE UNION MIX

General cleaning

Concrete

Terrazzo oor

Ceramic tiles/quarrystones

Marble

Vinyl tiles

Rubber tiles

Polishing

Rubber tiles

Marble

Vinyl tiles

Squeegee installation

7. Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.

Solution tank lling

CAUTION!

Use only low-foam and non-ammable detergents, intended for automatic scrubber applications.

WARNING!

When using oor cleaning detergents, follow the instructions on the labels of the detergent bottles.

To handle oor cleaning detergents, wear suitable gloves and protections.

8. Use the ller neck (45) to ll the tank (31) with a solution suitable for the work to be performed. Do not ll the solution tank

completely, leave few inches from the edge. Always follow the dilution instructions on the label of the chemical product used to

prepare the solution. The solution temperature must not exceed 104 °F (40 °C).

9099650000 - 07-2012.indb 13 24-Jul-12 15:10:40

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 97 98

No comments

Clarke Vantage 14 Service Manual Page 15