Clarke Vantage 14 Service Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 98
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
INSTRUCTIONS FOR USE ENGLISH
9099650000 - VANTAGE 17 B 11
USE
WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER
WARNING
CAUTION
CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates (see Visible Symbols On
The Machine paragraph).
Do not cover these plates for any reason and immediately replace them if damaged.
BATTERY CHECK/SETTING ON A NEW MACHINE
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by qualied personnel only.
Set the function electronic board and the battery charger according to the type of batteries used (WET or GEL).
Check the batteries for damage before installation.
Disconnect the battery connector and the battery charger plug.
Handle the batteries with great care.
Install the battery terminal protection caps supplied with the machine.
The machine requires two 12 V batteries, connected according to the diagram (51).
The machine can be supplied in one of the following modes:
GEL/AGM battery already installed on the machine
1. Ensure that the battery connector (29) is connected.
2. Start the machine (see Machine Start and Stop paragraph). If the green LED (64) turns on, the batteries are ready to be used.
3. If the yellow or red LED (64) turns on, the batteries must be charged (see the procedure in Maintenance chapter).
Without batteries
1. Buy appropriate batteries [See the Technical Data paragraph and the diagram (51)]. For battery choice and installation, apply
to qualied battery Retailers.
2. Set the machine and the battery charger (if equipped) according to the type of batteries installed, according to the procedure
shown in the following paragraph.
9099650000 - 07-2012.indb 11 24-Jul-12 15:10:38
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 97 98

Comments to this Manuals

No comments