Clarke Vantage 14 Service Manual download pdf (Page 14)

ENGLISH INSTRUCTIONS FOR USE

12 VANTAGE 17 B - 9099650000

BATTERY TYPE SETTING (WET OR GEL/AGM)

Set the electronic board of the machine and the battery charger

according to the type of batteries installed (WET or GEL/AGM)

as shown below:

Machine setting

1. Disconnect the battery connector (29).

2. The machine factory setting is for GEL/AGM batteries. If

this setting corresponds to the type of batteries installed,

go to step 6. Otherwise, perform steps 3, 4 and 5 too.

3. Remove the screws (A, Fig. 1), then remove the cover (B)

of the electrical component box (25).

4. On the electronic board, turn the microswitch (C) to WET

position.

WARNING!

Do not move/set the adjacent switch (D).

5. Reinstall the electric component box cover (B) and tighten

the screws (A).

Battery charger setting

6. To set the battery charger, refer to the relevant Manual

supplied with the machine.

Figure 1

P100640

Battery installation

7. Disconnect the vacuum hose (22) from the squeegee (11).

8. Disconnect the recovery water drain hose (16) from the

bracket (17).

9. Open the cover (6).

10. Grasp the recovery tank (A, Fig. 2) in the area (B) and

slightly raise it.

11. Disconnect the vacuum hose (C) from the tank, then

remove the tank (A) with the hoses (D) and (E).

12. Install the batteries on the machine according to the

diagram (51).

13. Install the tank (A) by performing steps 7 to 11 in the

reverse order.

Battery charging

14. Charge the batteries (see the procedure in Maintenance

chapter).

Figure 2

P100641

9099650000 - 07-2012.indb 12 24-Jul-12 15:10:40

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 97 98

Comments to this Manuals

No comments

Clarke Vantage 14 Service Manual Page 14

Comments to this Manuals

Related products and manuals for Vacuum cleaners Clarke Vantage 14