Clarke RACER 9/50P Operations Instructions download pdf (Page 9)

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

TURNING THE COMPRESSOR ON

1. Plug the compressor into the power supply.

Lift the On/Off button.

• The compressor will operate

until the reservoir is fully

pressurised. It will then shut

down.

• The compressor will start up

again when the pressure in the

reservoir decreases.

CHECK THE SAFETY VALVE

To make sure that the safety valve works correctly.

Pull on the ring attached.

• Air will be released when you

pull on the ring and

stop when

released.

2. If the valve does not operate in

this way, do not use the

compressor. The compressor must

be repaired by a qualified service

agent.

SET THE OUTLET PRESSURE

1. Use the pressure regulator to set

the outlet pressure.

• Turn clockwise to increase the

pressure.

• Turn counterclockwise to

decrease the pressure.

WARNING: DO NOT REMOVE OR TRY TO ADJUST THE SAFETY VALVE.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Clarke RACER 9/50P Operations Instructions Page 9