Clarke CMD10 Specifications download pdf (Page 10)

OPERATION

When first using the machine, please use

the following procedure.

1. Select LOW range, by moving the

Lever, adjacent to the Emergency

Stop, fully to the ‘L’ position.

2. Push the emergency OFF switch cover

button (fig.2) upwards in direction of

arrow. This will allow the cover to spring

outwards, releasing the OFF button.

3. Start the machine by turning the rotary

ON/OFF, variable speed switch, slowly

Ensure the work area is clean and tidy and all tools and accessories etc., are removed

and stored safely, before plugging the machine into the electric supply.

Switch the power ON. At this point, the green indicator lamp on the switch panel on the front

of the machine, will illuminate, indicating that power is being supplied to the machine.

clockwise to mid position, and allow to run for a minute or two

before winding up to full speed, then allow to run for a further two minutes.

4. Switch OFF by turning the rotary switch fully anticlockwise, then move

the Hi-Lo range lever to the ‘H’ - high position, and repeat the process.

NOTE: In case of emergency, hit the switch cover quickly. The cover will

latch down and the motor will be switched OFF.

The machine will not start when the emergency switch cover is closed.

If the emergency switch is used to switch OFF, when the rotary ON/OFF

switch in the ON position, the machine will not start again when the

emergency switch is released. The amber warning lamp will also illuminate.

The rotary switch must first be turned OFF then turned ON again to start the machine.

Once the machine has been ‘run up’ check to ensure that the machine is secure on the

bench or board, and check again to ensure the post is secure by attempting to tighten the

post securing nut at the rear of the machine using the 36mm spanner provided.

Fig.3

Fig.2

Fig.4

A. Drilling

The machine is provided with a drill

chuck and morse taper shank - Fig.4.

Insert the taper shank up into the

spindle, sharply.

CAUTION. Take extreme care not to

damage the taper in any way. Any

burr or irregularity will render it

unserviceable until it is properly

repaired using a grind stone.

Professional advice should be sought.

Fig.5

Pull off the spindle draw bolt cover from the head (see Parts ID, Fig-C on page

8s) and insert the draw bolt . Screw it into the end of the taper shank and

tighten using the spanner provided - see Fig.5.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments

Clarke CMD10 Specifications Page 10

Comments to this Manuals

Related products and manuals for Power drills Clarke CMD10