Clarke Vantage 14 Service Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
ENGLISH
18
Instructions For Use - VANTAGE 14
FUSE CHECK/REPLACEMENT/RESET
Drive the machine on a level oor.1.
Turn the knob (32) to “0” and disconnect the battery (7).2.
Open the cover (4) and check one of the following fuses 3.
for deactivation or integrity:
(A, Fig 7): F1 (30 A) circuit breaker, brush motor.
(B): F3 (5 A) blade fuse, accessories.
(C): F2 (30 A) blade fuse, vacuum system motor.
Reset any deactivated fuse, when the component that
caused deactivation has fully cooled down.
NOTE
If fuse reset or replacement does not restore
operation, refer to Service Manual or contact Clarke
Close the cover (4).4.
B
A
C
Figure 7
P100414
TROUBLESHOOTING
Trouble Possible Cause Remedy
The motors do not turn on; no warning
light turns on.
The battery connector is disconnected. Connect.
The battery is fully discharged. Charge.
The F3 fuse is blown. Replace.
The brush motor does not run. The F1 fuse has triggered. Reset the fuse.
The vacuum system motor does not
turn on.
The F2 fuse is blown. Replace.
The dirty water vacuuming is
insufcient.
The recovery tank is full. Empty.
The vacuum grid is clogged or the oat is closing. Clean the grid and check the oat.
The vacuum hose is disconnected from the squeegee
or faulty.
Connect.
The squeegee is dirty, or the squeegee blades are
worn or damaged.
Clean the squeegee or replace the blades.
The recovery tank cover is not properly closed, or the
gaskets are damaged.
Check and/or clean the seating surface or replace
the gaskets.
The vacuum system motor lter is dirty. Clean.
The solution ow is insufcient. The detergent duct is dirty/clogged. Clean.
The squeegee leaves marks on the
oor.
There is debris under the squeegee blades. Remove the debris.
The squeegee blades are worn, chipped or torn. Replace the blades.
For further information refer to the Service Manual, available at any Clarke Service Center.
SCRAPPING
Have the machine scrapped by a qualied scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
Battery
Brushes
Plastic hoses and components
Electrical and electronic components (*)
Refer to the nearest Clarke Center especially when scrapping electrical and electronic components.(*)
A1 ENGLISH.indd 18 03/08/2011 14.54.51
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 75 76

Comments to this Manuals

No comments