Clarke Vantage 14 Service Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
ENGLISH
Instructions For Use - VANTAGE 14
17
MACHINE SPEED ADJUSTMENT
NOTE
The machine speed varies according to the type of oor to be cleaned and the choice of using the brush or the pad.
If necessary, perform the following procedure.
Remove the recovery and the detergent tanks as shown in Tank, cover and vacuum grid cleaning paragraph.1.
Adjust the machine speed with the handwheel (A, Fig. 6) according to the following procedure:2.
Turn it counter-clockwise to increase the machine speed.
Turn it clockwise to decrease the machine speed.
If it is difcult to keep the machine moving straight-forwardly because it deviates to the left or to the right, adjust the handwheel 3.
(B) by turning it clockwise or counter-clockwise.
After adjusting, install the tanks as shown in Tank, cover and vacuum grid cleaning paragraph.4.
With the machine ready to operate, perform hands-on tests of the machine and, if other adjustments are necessary, repeat 5.
steps 1 to 4.
A
B
Figure 6
P100413
BATTERY CHARGING
NOTE
Charge the batteries when the yellow or red warning light turns on, or at the end of each working cycle. Keeping the
battery charged extend the life of the battery.
CAUTION!
When the battery is discharged, charge as soon as possible.
Check for battery charge at least once a week.
Drive the machine on a level oor.1.
Turn the knob (32) to “0”.2.
Connect the battery charger cable (10) to the electrical mains (the electrical mains voltage and frequency must be compatible 3.
with the battery charger values shown on the relevant Manual).
NOTE
When the battery charger is connected to the electrical mains, all machine functions are automatically cut off.
The red or yellow warning light (38) is on when the battery charger is charging the batteries.
When the green warning light (38) stays on, the battery charging cycle is over.4.
When the battery charging is completed, disconnect the battery charger cable (10) from the electrical mains and wind it around 5.
its housing.
The machine is now ready to be used.6.
NOTE
For further information about the operation of the battery charger (26), see the relevant Manual.
A1 ENGLISH.indd 17 03/08/2011 14.54.50
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 75 76

Comments to this Manuals

No comments