Clarke Vantage 14 Service Manual download pdf (Page 13)

ENGLISH

Instructions For Use - VANTAGE 14

BEFORE MACHINE START-UP

Brush/pad-holder installation/removal

NOTE

Install either the brush (A, Fig. 1) or the pad-holder (B and C) according to the type of oor to be cleaned.

Lift the brush/pad-holder deck (12) using the handlebar (1).1.

Place the brush (A, Fig. 1) or the pad-holder (B and C) under the deck (12).2.

Lower the deck (12) by using the handlebar (1).3.

Turn the knob (32) on one of the indicated programs.4.

Press the enabling push-button (39) together with the brush levers (40) to engage the brush/pad-holder.5.

To remove the brush/pad-holder, perform the following procedures.

Switch off the machine by turning the knob (32) to “0”.6.

Lift the machine deck using the handlebar (1), then manually release the brush/pad-holder from the hub, by turning it abruptly 7.

in its normal rotation direction (D, Fig. 1).

Front

Figure 1

P100407

Available brushes and their relevant application guides (suggestions only and see Recommended spare parts

for part numbers)

Models MIDLITE GRIT 180 MIDGRIT 240 PROLITE UNION MIX

General cleaning

Concrete

Terrazzo oor

Ceramic tiles/quarrystones

Marble

Vinyl tiles

Rubber tiles

Polishing

Rubber tiles

Marble

Vinyl tiles

Solution tank lling

Open the ller neck (21), ll the tank (22) with a solution suitable for the work to be performed. Do not ll the solution tank 8.

completely, leave a few inches from the top. Always follow the dilution instructions on the label of the chemical product used to

prepare the solution. The solution temperature must not exceed 104° F (40°C).

CAUTION!

Use only low-foam and non-ammable detergents, intended for automatic scrubber applications.

Adjustments

Adjust the height and the inclination of the handlebar (1) with the lever (2) to reach a comfortable position.9.

A1 ENGLISH.indd 11 03/08/2011 14.54.48

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

No comments

Clarke Vantage 14 Service Manual Page 13