Clarke JETSTAR 1750 Operations Instructions download pdf (Page 14)

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

TROUBLESHOOTING

If the following does not solve your problem, please contact the CLARKE service

department.

ACCESSORIES

The range of accessories listed below may be purchased from your CLARKE

dealer.

FAULT CAUSE SOLUTION

Pressure drop. Air in system. Bleed system by quickly operating

trigger several times.

Pressure

fluctuations or

pressure drop.

Shortage of water. Turn water tap on fully.

Water supply hose too long/

too narrow.

Use a 1/2” diameter water supply hose.

No water due to clogged

inlet filter.

Clean water inlet filter.

Motor does not

start when

switched on.

Plug is not connected

properly.

Check plug and lead and have them

replaced by a qualified electrician if

necessary.

Mains fuse tripped/blown. Renew fuse or reset.

Motor hums

when trigger

operated and

does not start.

Mains voltage too low. Have electrical connection checked.

Pump seals stuck. Contact your Clarke dealer.

Cleaning agents

are not being

supplied.

Container empty. Fill container

ITEM PAR T N UMB ER

5 Litres Detergent (Traffic Film Remover) 3050821

25 Litres Detergent (Traffic Film Remover) 3050820

5 Litres Wash ‘n’ Wax 3050815

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Clarke JETSTAR 1750 Operations Instructions Page 14

Comments to this Manuals

Related products and manuals for High-pressure cleaners Clarke JETSTAR 1750