Clarke JETSTAR 1750 Operations Instructions download pdf (Page 13)

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

MAINTENANCE

CLEANING THE NOZZLE

If the nozzle becomes clogged with foreign materials such as dirt or calcium,

excessive pressure may develop. If the nozzle becomes partially clogged or

restricted, the pump pressure will pulsate, clean the nozzle immediately by

following the instructions below:

1. Turn off the pressure washer and

turn off the water supply.

2. Pull trigger to release any water

pressure in the hose.

3. Disconnect the lance from the

gun.

4. Remove any obstructions with the

nozzle cleaning tool provided.

5. Direct water from a tap into the

end of the lance for 30 seconds to back flush loose particles.

6. Reconnect the lance to gun and turn on water supply.

CLEANING THE WATER INLET FILTER

This filter should be checked periodically and cleaned if necessary.

1. Remove the inlet filter from the

pressure washer as shown.

2. Clean the filter by flushing both

sides with water.

3. Replace the filter into the water

inlet.

• Tapered side faces in.

NOTE: Do not operate the pressure

washer without filter installed.

WARNING: THE PRESSURE WASHER SHOULD BE DISCONNECTED FROM THE

MAINS POWER SOCKET DURING CLEANING OR MAINTENANCE.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Clarke JETSTAR 1750 Operations Instructions Page 13