Clarke Vantage 14 Operator's Manual download pdf (Page 19)

ENGLISH

Operator’s Manual - Vantage 13 17

VACUUM GRID, DETERGENT TANK AND RECOVERY TANK CLEANING

Drive the machine to the appointed disposal area.1.

Make sure that the power supply cable (10) is disconnected from the electrical mains.2.

Open the transparent cover (A, Fig. 4) and clean it carefully.3.

Clean the vacuum grid (B) with care. If necessary disconnect the hoses (20 and 21).

Check the transparent cover gasket (C) for integrity.4.

NOTE

The gasket (C) creates vacuum in the tank that is necessary for vacuuming the recovery water.

If necessary replace the gasket (C) by removing it from its housing (A).

Check that the seating surface (D) of the gasket (C) is integral and adequate for the gasket itself.5.

Drain and wash the recovery tank (16) and the detergent tank (14) as shown in Use chapter.6.

Install the tanks and the transparent cover with the vacuum grid.7.

Figure 4

P100315

SOLUTION HOSE FILTER CLEANING

Drive the machine on a level ground.1.

Make sure that the power supply cable (10) is disconnected from the electrical mains.2.

Remove the solution hose plug (A, Fig. 5), carefully remove the hose from the tank and clean the ﬁ lter (B) with water.3.

If necessary, remove the ﬁ lter and replace it with a new one.

Install the ﬁ lter with the solution hose inside the tank, than install the plug.4.

Figure 5

P100316

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 75 76

No comments

Clarke Vantage 14 Operator's Manual Page 19