Clarke SUBMERSIBLE PUMP Instruction Manual download pdf (Page 3)

ELECTRICAL CONNECTIONS

230V models should have their mains lead connected to a standard 230Volt (50Hz)

electrical supply through an approved plug or a suitably fused isolator switch.

110V models should have their mains lead connected to a suitable 110V supply (50Hz)

through an approved plug or suitably fused isolator switch, or to a suitable portable 110V

transformer.

We recommend that these pumps be fitted with a Residual Current Device (RCD).

If the pump is to be connected to an outdoor electrical supply, make sure that both the

plug and the socket are of a BS approved waterproof design.

In the event that the pump is hard wired into the electrical system, it must be carried out

in accordance with IEE regulations.

If used for draining swimming pools or ponds, the pump MUST be fitted with a Residual

Current Device (RCD), with a rated residual operating current of no greater than 30mA.

WARNING: THIS APPLIANCE MUST BE EARTHED

230V only

IMPORTANT: The wires in the mains lead are coloured in accordance with the following

code: Green & Yellow - Earth

Blue - Neutral

Brown - Live

As the colours of the flexible cord of this appliance may not correspond with the coloured

markings identifying terminals in your plug proceed as follows:

Connect GREEN & YELLOW cord to plug terminal marked with a letter “E” or

Earth symbol “ “ or coloured GREEN or GREEN & YELLOW.

Connect BROWN cord to plug terminal marked with a letter “L” or coloured RED

Connect BLUE cord to plug terminal marked with a letter “N” or coloured BLACK

FUSE RATING

The fuse in the plug for this appliance must be rated at 13 amps.

If this appliance is fitted with a plug which is moulded onto the electric cable (i.e. non-

rewirable) please note:

1. The plug must be thrown away if it is cut from the electric cable. There is a danger of

electric shock if it is subsequently inserted into a socket outlet.

2. Never use the plug without the fuse cover fitted.

3. Should you wish to replace a detachable fuse carrier, ensure that the correct

replacement is used (as indicated by marking or colour code).

4. Replacement fuse covers can be obtained from your local dealer or most electrical

outlets

5. The fuse in the plug must be replaced with one of the same rating (13 amps) and

this replacement must be ASTA approved to BS1362.

IMPORTANT:If you are in any doubt regarding electrical installation, you should

consult a qualified electrician.

1 2 3 4 5 6 7

No comments

Clarke SUBMERSIBLE PUMP Instruction Manual Page 3