Clarke SUBMERSIBLE PUMP Instruction Manual download pdf (Page 2)

Thank you for purchasing this CLARKE, HIPPO Submersible Pump.

These highly efficient pumps are designed for pumping clean water only, and are ideally

suited for draining ornamental ponds, swimming pools etc.Water temperature must not

exceed 35° C.

The HIPPO-3A differs from the HIPPO-3 in that it incorporates a float switch, which

automatically switches the pump OFF and ON when the water reaches a pre-determined

level. The minimum suction level being 5mm. Both models are available for use with 110V

and 230V supply’s. Please take note of the information regarding Electrical Installation .

Before attempting to operate your pump, please read this instruction manual thoroughly

and follow all directions carefully. This is for your own safety and that of others around

you, and to help you achieve long and trouble free service from your pump.

GUARANTEE

This product is guaranteed against faults in manufacture for 12 months from purchase

date. Keep your receipt as proof of purchase.This guarantee is invalid if the product has

been abused or tampered with in any way, or not used for the purpose for which it is

intended. The reason for return must be clearly stated. This guarantee does not affect

your statutory rights.

Please note that dismantling this pump will invalidate the guarantee

SAFETY PRECAUTIONS

1. These pumps are designed to pump CLEAN WATER ONLY. Never use for pumping

flammable liquids or chemicals.

2. Never run the pump dry.

3. An approved Residual Current Device (RCD) MUST be used when pumping from

ponds or swimming pools.

4. Your submersible pump may ONLY be used for pumping water from

a swimming pool when there is no person or animal in the pool.

5. Always disconnect the pump from the electrical supply before

placing it into, or removing it from the water, and before any

cleaning or maintenance of the pump.

6. Always use the moulded handle with a rope or cord attached

when lifting the pump. NEVER lift the pump by the mains

cable, or, where fitted, the float switch cable.

7. DO NOT run the pump with the body exposed for longer

than 10 minutes.

8. DO NOT install the pump on ground which is likely to shift.

9. Do not use the pump if the water is liable to freeze, as this can cause damage to the

pump. Remove the pump from the water and store it in a frost free location.

1 2 3 4 5 6 7

No comments

Clarke SUBMERSIBLE PUMP Instruction Manual Page 2