Clarke ENCORE S2426 Operator's Manual download pdf (Page 16)

ENGLISH

Page -16- Clarke

Operator's Manual (EN) - Encore S2426 / L2426 / S2426 OBC / L2426 OBC

4. Observe indicator light to ensure the charging process has

started. Flashing light(s) indicates that the batteries are being

charged. Steady on green light indicates the batteries are fully

charged.

NOTE: Make sure you plug into a circuit that is not loaded by other

equipment. Wall breakers may be tripped and no charge will occur.

WARNING: Never charge a GEL battery with an unsuit-

able battery charger. Carefully follow the

instructions given by the manufacturer of

the batteries and battery charger.

NOTE: To prevent permanent damage to the batteries, avoid their

complete discharge. Never leave the batteries completely dis-

charged, even if the machine is not being used. When recharging

the batteries, keep the recovery tank open. After every 20 recharging

cycles, check the level of the electrolyte and if necessary top off with

distilled water.

How To Adjust Brush Cleaning Path from 24" to 26"

1. Insure brush head is in up position.

2. Turn the key switch "OFF" and remove the key.

3. Open front cover.

4. Raise plunger pin and rotate brush head. See figure 16.

5. Insure plunger pin is engaged in brush plate.

6. Close front cover.

How To Install The Brushes Or Pad Drivers

To install the brushes or pad drivers on the machine,

follow this procedure:

1. Turn the key switch "ON".

2. Raise the brush head by pressing and holding the brush

switch until brush head is in its full up position.

3. Turn the key switch "OFF" and remove the key.

4. Go to the front of the machine and unlatch front cover, swing

cover open.

5. Unlatch right and left brush housings and remove them. See

figure 17A.

6. Put a brush or pad driver under the brush motor plate. See

figure 17B.

7. ("L" Model) Align the lugs on the motor gimbal with the slots

in the brush gimbal.

("S" Model) Align the lugs on the motor with the slots on the

brush gimbal.

8. ("L" Model) Pull the brush up until the gimbal locks.

("S" Model) Pull the brush up and rotate counter direction to

scrub rotation, until lugs lock.

9. Repeat steps 6, 7, and 8 to install the second brush or pad

driver.

10. Reinstall right and left brush housings and latch front cover.

DANGER: Operating a machine that is not completely or

fully assembled could result in injury or

property damage. Do not operate this machine

unless it is completely assembled. Inspect the

machine carefully before operation.

How To Prepare the Machine For Operation

Figure 16

Figure 17A

Figure 17B

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 119 120

Comments to this Manuals

No comments

Clarke ENCORE S2426 Operator's Manual Page 16

Comments to this Manuals

Related products and manuals for Vacuum cleaners Clarke ENCORE S2426