Clarke ENCORE S2426 Operator's Manual download pdf (Page 15)

ENGLISH

Clarke

Operator's Manual (EN) - Encore S2426 / L2426 / S2426 OBC / L2426 OBC - 15 -

How To Prepare the Machine For Operation

Figure 14A

Figure 14B

Figure 15

4. Disconnect the battery pack connector from the control housing

connector. See figure 14A.

5. Connect the DC connector on the charger to the battery pack

connector. See figure 14B.

6. Connect the charger to a properly grounded single phase (3-

wire) wall receptacle having the input voltage, frequency, and

ampere capacity specified on the nameplate of the charger.

For more information on the use of the charger, read

the instructions supplied with the charger.

How To Charge The Batteries With On-Board Charger

WARNING: Charging the batteries in an area without ad-

equate ventilation could result in an explosion.

To prevent an explosion, charge the batteries

only in an area with good ventilation.

WARNING: Lead acid batteries generate gases which could

explode. Keep sparks and flames away from

batteries. NO SMOKING!

CAUTION: See Charger Owner’s Manual. All onboard

battery chargers are programmed for a

specific type battery. The charger may need

reprogramming to properly charge

replacement batteries different than the

originally equipped Clarke battery.

NOTE: Only replace batteries with the identical Clarke battery

pack as originally equipped. The correct Clarke battery part

number can be found on the Clarke battery label affixed to the top

of each battery.

If the replacement battery is a different Clarke battery, please

contact Clarke Technical Service, 1-800-356-7274, for

instructions.

If the replacement battery is not a Clarke battery, please contact

the charger manufacturer for instructions.

To charge the batteries with the on-board charger, follow this

procedure:

1. Place the key switch is in the “OFF” position.

2. Before charging the batteries, the battery compartment needs to be

vented. To vent compartment, tip up the recovery tank until it locks

in the open position (see figure 15). To close the tank, pull up on

the arm and then slowly lower the tank to the closed position.

CAUTION: Before raising tank, be sure tank is empty.

WARNING: Do not operate or perform maintenance on the

machine while the recovery tank is in the open

position. The tank can be accidentally bumped

and it may slam shut.

3. Connect the battery charger AC cord located at the rear of the

machine to a 15 amp (min) 120V properly grounded wall recep-

tacle.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 119 120

Comments to this Manuals

No comments

Clarke ENCORE S2426 Operator's Manual Page 15

Comments to this Manuals

Related products and manuals for Vacuum cleaners Clarke ENCORE S2426