Clarke JET 8000 Instruction Manual download pdf (Page 10)

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

OPERATION

GETTING STARTED

1. Ensure that the water supply is correctly connected and turned on.

2. Plug the power cable into the

mains supply.

3. Release the trigger lock.

• The pressure washer is now

ready for use.

4. Press the start switch (‘I’).

5. Pull the trigger.

NOTE: When the trigger is pulled the

pressure of water will cause

the lance/gun assembly to

kick back suddenly.

6. When using the power washer for

the first time, let it run for a few

moments so that any air bubbles

or other impurities are discharged.

7. Release the trigger to stop the water flow.

• This pressure washer is fitted with an auto stop system to protect the

motor during use.

• When the trigger is released, the motor will stop. When the trigger is

squeezed the motor will start up again.

WARNING: FAILURE TO TURN ON THE WATER FULLY COULD CAUSE

DAMAGE TO THE POWER WASHER INTERNAL COMPONENTS.

WARNING: DO NOT USE THE POWER WASHER IF THE SUPPLY CABLE OR

IMPORTANT PARTS OF THE MACHINE ARE DAMAGED, E.G. SAFETY

DEVICES, HIGH PRESSURE HOSES, TRIGGER

WARNING: WE RECOMMEND THAT THIS MACHINE IS CONNECTED TO THE

MAINS SUPPLY VIA A RESIDUAL CURRENT DEVICE (RCD)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Clarke JET 8000 Instruction Manual Page 10