Clarke EXT 311 Operator's Manual download pdf (Page 8)

Clarke

Ext- 311 Owner's Manual Page 7

INSTRUCTIONS FOR CONNECTION TO THE

POWER SUPPLY AND ELECTRICAL GROUND - 120 V

CAUTION: This machine will operate only on an AC

frequency and on the specified electrical

voltage shown on the nameplate. Make

sure you have the correct frequency and

voltage before connecting the power

cord to an outlet.

This machine must be connected to an electrically ground

circuit in order to protect the operator from electric shock. This

machine has an approved power cord with three conductors as

well as a plug with three terminals. Connect the plug to a three

holed receptacle. For maximum protection against electric

shock, use a circuit that is protected by a ground fault circuit

interrupter.

This machine uses a 120 volt AC 50/60 cycle electrical circuit.

Make sure you have the correct frequency and voltage before

connecting the power cord to an outlet. The machine has a plug

as shown in Figure 5. If a receptacle connected to the electrical

ground as shown in Figure 5 is not available, contact an

electrical contractor. Do not us an adapter.

WARNING: To prevent possible electric shock, pro-

tect the machine from rain. Keep the

machine in a dry building.

WARNING: To prevent possible electric shock, al-

ways use a 3-wire electrical system con-

nected to the electrical ground. For

maximum protection against electrical

shock, use a circuit that is protected by a

ground fault circuit interrupter. Consult

your electrical contractor.

WARNING: Do not cut, remove, or break the ground

pin. If the outlet does not fit the plug,

consult your electrical contractor.

WARNING: If the cords or plugs are worn or dam-

aged in any way, have them replaced by

an authorized service person.

Extension Cords

Use only an approved extension cord with three conductors, a

plug with three terminals and a three-holed connector body.

This machine has a power cord with a wire size of 16 AWG.

(AWG stands for American Wire Gauge).

CAUTION: If you use an extension cord, use one that

has a minimum wire size of 14 AWG. Be

sure your extension cord is no longer

than 50 ft. Do not join two extension

cords.

Figure 5

Plate

Screw

Outlet must be

connected to

the electrical

ground

Ground Pin

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 56 57

Comments to this Manuals

No comments

Clarke EXT 311 Operator's Manual Page 8

Comments to this Manuals

Related products and manuals for Vacuum cleaners Clarke EXT 311