Clarke Vantage 17 cable Operator's Manual download pdf (Page 20)

ENGLISH

20 Operator’s Manual - Vantage 17 Cable

SOLUTION FILTER CLEANING

1. Empty the solution tank (A, Fig. 20) according to the

procedure shown in the relevant paragraph.

2. Make sure that the power supply cable (H, Fig. 20) is

disconnected from the electrical mains.

3. Drive the machine on a level ground.

4. Remove the transparent cover (D, Fig. 20) and the filter

strainer (E), then clean and reinstall them on the support

(F).

MACHINE SPEED ADJUSTMENT

1. Remove the recovery tank as shown in the Use chapter.

2. Adjust the machine speed by means of the screw (A, Fig.

21), according to the following procedure:

– Loosen the screw (B, Fig. 21) on the right side of the

machine, by turning it counter-clockwise.

– Turn the adjusting screw (A, Fig. 21)

counter-clockwise to increase the machine speed.

– Turn the adjusting screw (A, Fig. 21) clockwise to

decrease the machine speed.

– After adjusting, tighten the screw (B, Fig. 21).

3. Install the recovery tank as shown in the Use chapter.

4. With the machine ready to operate, carry out hands-on

tests of the machine speed and, if other adjustments are

necessary, repeat steps 1 to 4.

NOTE:

Properly install the strainer (E, Fig. 20) in the

housing (G) of the support (F).

NOTE:

The machine speed depends on the type of floor to

be cleaned and on the choice of using brush or pad.

The machine speed can be adjusted according to

the following procedure.

Figure 20

Figure 21

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 89 90

No comments

Clarke Vantage 17 cable Operator's Manual Page 20