Clarke Focus II Rider Operator's Manual download pdf (Page 8)

ENGLISH

Page -8-

Clarke

Operator's Manual (EN) - Focus Rider

On/Off Key Switch (See figure 1, Item D)

The key switch turns “ON” the power to the control

panel. “O” is the “OFF” and “I” is the “ON”.

Brush Up/Down Switch (See figure 1, Item A)

To lower brush head, push the brush switch in the

down (+) position. To lower the brush head to maxi-

mum brush pressure, continue to hold the switch in

the down (+) position until the travel stops. The brush

motors will start and solution will flow (provided the

solution is turned “ON”) when the machine begins to

traverse. To raise the brush head, push the brush

switch in the up (-) position until the brush head travel

stops or desired position is reached.

Squeegee Up/Down Switch (See figure 1, Item B)

The squeegee switch is used to raise and lower the

squeegee and to turn on and off the vacuum motor.

The vacuum motor is turned on when the switch is

placed in the middle or lower position. NOTE: When

the squeegee switch is placed in the lower

position, the vacuum motor will turn on.

To raise the squeegee, place the switch in either the

middle or up position. The middle position is used for

one touch control. The vacuum motor will stop, after a

short delay, when the switch is placed in the up

position.

Hour Meter (See figure 1, Item E)

The hour meter is located on the front display. You

must toggle screens using LCD display button. The

hour meter indicates the number of hours the machine

has operated. It displays brush motor, vacuum motor,

traverse motor and total key on times.

Battery Meter (See figure 1, Item F)

The battery meter indicates the relative charge on the

battery pack. The battery meter is located on screen

1 on the front display. See page 7.

Solution Flow Control (See figure 1, Item C)

The solution flow switch regulates the flow of chemical

solution to the floor. To increase the flow, toggle (+).

To decrease the flow, toggle (-). To shut off the

solution, toggle - until no indicators are visible on

display (see figure 2). NOTE: DO NOT run dry!

NOTE: No solution will flow when the machine

does not traverse.

Circuit Breakers

The circuit breaker reset buttons are located on the

back side of the front cover below front display. The

breakers are as follows:

Item A - Main (5 amp)

Item B - Key Switch (5 amp)

Machine Control Panel

Figure 1

E, F

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 67 68

Comments to this Manuals

No comments

Clarke Focus II Rider Operator's Manual Page 8

Comments to this Manuals

Related products and manuals for Floor Machine Clarke Focus II Rider