Clarke CS4-6C Specifications download pdf (Page 11)

Auxiliary Mounting For Vertical Sanding

1. Remove backstop lock bolt and remove

work support.

2. Remove table assembly by removing table

lock knob and washer.

NOTE: Belt bed may be raised to vertical

position by loosening hex socket screw and

raising bed. See “Positioning Belt Bed” on page

16.

3. Attach table assembly to auxiliary holes in

belt bed. Make sure index pin is in the

upper hole when sanding table is in the

vertical position.

Squaring Table Assembly

WARNING: To avoid injury from accidental start,

make sure tool is unplugged before aligning.

1. Using a combination square, check the

angle of the worktable with the disc.

NOTE: The combination square must be “true”

- See “Assembly - Tools Needed” section on

page 8 for checking method

2. If the table is not 90º with the disc, loosen

table lock knob screw and tilt table.

3. Adjust worktable square to the disc and

retighten table lock knob.

4. Attach scale label to 0º mark on dust guard.

Installing the Sanding Belt -Tensioning And Tracking

WARNING: To avoid injury from accidental start,

switch “OFF”, remove key and disconnect from power

outlet before removing or installing sanding belt.

On the smooth side of the sanding belt, is a “directional

arrow.” The sanding belt must run in the direction of this

arrow so that the splice does not come apart.

1. Slide tension lever to the right to release the belt

tension.

2. Place the sanding belt over the pulleys with the

directional arrow pointing as shown.

Make sure the belt is centred on both pulleys.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

No comments

Clarke CS4-6C Specifications Page 11