Clarke CWL325V Instruction Manual download pdf (Page 11)

2. Using the allen key supplied,

loosen the bolts (39) to enable

the motor to move and the drive

belt to go slack.

3. Dismount the drive belt from the

motor pulley (34) and then lift it

off the drive pulley (31) towards

you. Use the allen key to help you

as shown in Fig 4. The belt can

now be removed from the

headstock frame.

4. Replacement is a reversal of the

removal procedure. Tension the belt by hinging the motor downwards

prior to tightening the bolts (39).

Please refer to TROUBLESHOOTING on page 12. If you are unable to rectify

any faults, please contact your local dealer or Clarke International Service

Department on 0208 988 7400 for assistance.

Fig 4

TECHNICAL SPECIFICATION

Please note that the details and specifications contained herein, are correct at the

time of going to print. However, CLARKE International reserve the right to change

specifications at any time without prior notice.

erutaeF noitacificepS

thgieWgk12

)HxWxL(snoisnemiD )txetserloot&kcotsliat(mm003x222x237

deepS )elbairav(mpr0913-098

sertnecneewtebecnatsiDmm523

yticapaCgninruTmm002

daerhTeldnipS )FNU(IPT61x"4/3

gnitaRPI02PI

ycneuqerf/egatlovrotoMzH05/V032

egattaWtupnIdetaRW052

leveLerusserPdnuoS )A(BdApL5.28dedaoL/3.57daoloN

leveLrewoPdnuoSderusaeM )A(BdAwL8.19dedaoL/3.48daoloN

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Clarke CWL325V Instruction Manual Page 11