Clarke CWL325V Instruction Manual download pdf (Page 10)

OPERATION

1. Press the green push-button to start the lathe and adjsut the speed using

the speed control knob.

2. Always use the lowest speed when starting a new workpiece.

3. Always rotate the workpiece by hand before turning on the motor and

check it does not strike the tool/tool rest.

4. Ensure tool rest and tailstock are securely locked in position before starting

work.

5. Always position the tool-rest just above the centre-line of the lathe.

6. Avoid turning timber which has splits or substantial knots or voids and take

special care if these are discovered.

7. When turning, always roughly turn the work to a round form at slow speed.

8. Take care that the turning tools do not bite suddenly into the workpiece.

MAINTENANCE

For maximum performance, it is essential that the machine is properly

maintained. Always inspect before use. Any damage should be repaired and

faults rectified. The machine requires very little maintenance other than the

following guidelines.

IMPORTANT - Disconnect from mains power before cleaning.

1. Vacuum clean any dust or shavings that accumulate in or on the motor.

2. Check all cables periodically and ensure that they are in good condition

and not cracked.

3. Check the tightness of the mounting bolts.

4. Check the drive belt for wear and replace if it is frayed or otherwise

damaged.

5. Periodically lubricate the tail-stock, screw threads with engine oil such as

SAE20 or SAE30 grade if they become stiff to use.

6. Lightly lubricate the tail-stock and tool-post locking handles with oil if they

become difficult to use.

• The ball bearings in the headstock and tail-stock spindles are greased and

permanently sealed at the factory and require no further lubrication.

REPLACING THE BELT

Note: Part numbers refer to the Parts Diagram on page 13.

1. Undo the three screws (28) and remove the end cover (27).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Clarke CWL325V Instruction Manual Page 10