Clarke RS-16 User Manual download pdf (Page 8)

ENGLISH

-8-

Clarke

American Sanders

Operator's Manual (EN) - RS-16 /RS-16DC

Figure 4

HOW TO OPERATE THE MACHINE

OPERATION (Figure 4)

1 Unwrap the Power Cord (5) and plug it into a

properly grounded outlet.

2 Pull up on the Handle Release Compression Lever

(4). Move the Operator Handle (6) downward until

your arms are almost straight. Push down on the

Handle Release Compression Lever (4) to lock it in

place.

3 Lift up on the Operator Handle (6) until the brush (or

pad) is flat against the floor.

WARNING! Be prepared to control the machine as

soon as the motor starts. Just a slight

up or down movement of the Handle

will make the machine move from side

to side. Raise the Handle to go right.

Lower the Handle to go left.

CAUTION! Immediately start moving the machine

back and forth. Keep the machine

moving while the motor is running to

avoid damage to the floor.

4 Hold one of the Operator Hand Grips (1) firmly, push

the Safety Lock Button (2) and then compress the

Switch Levers (3) to start the motor. NOTE: When

the Switch Levers (3) are released, the machine

shuts off immediately.

AFTER USE (Figure 4)

1 Place the Operator Handle (6) in the upright position

and unplug the Power Cord (5). Wrap the Power

Cord (5) around the Operator Handle Grips (1) and

the Cord Hook (7).

2 Remove the pad driver from the machine. Never

store the machine with the pad driver on the

machine.

3 Wipe the entire machine with a clean, damp cloth.

4 Inspect the entire machine and all accessories for

damage. Perform any required maintenance or

repairs before storage.

5 Store the machine in a clean, dry place with the

Operator Handle (6) locked in the upright position.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

Comments to this Manuals

No comments

Clarke RS-16 User Manual Page 8

Comments to this Manuals

Related products and manuals for Grinding machines Clarke RS-16