Clarke ultra speed Operator's Manual download pdf (Page 7)

ENGLISH

Clarke

Operator's Manual (EN) - Ultra Speed

20 / 20T FORM NO. 56091104 - 7 -

HOW TO PREPARE THE MACHINE FOR OPERATION

How To Install The Batteries

This machine uses three 12-volt batteries. The batteries are

located in the battery compartment under the battery cover.

WARNING: Lifting batteries without help

could result in an injury. Get help to lift

the batteries. The batteries are heavy.

WARNING: Working with batteries can be

dangerous. Always wear eye protection

and protective clothing when working

near batteries. NO SMOKING!

To Install the batteries, follow this procedure:

1. Make sure the key switch is in the OFF position (O).

2. Carefully lift the batteries into the battery tray. Arrange

as shown in ﬁ gure 5.

3. Install the battery cables as shown in ﬁ gure 5, with the

terminals marked "P" on the positive battery posts and

the terminals marked "N" on the negative batter posts.

Position the cables so that the caps can be easily re-

moved when it is necessary to add water to the batter-

ies.

4. Tighten the nut on each battery terminal just enough to

keep the terminal from being turned on the battery post.

Then tighten the nut one more full turn.

5. Coat all the terminals and posts with grease, petroleum

jelly or spray on battery coating (available in most auto

parts stores).

6. Put on the black rubber "boots" over each of the termi-

nals and use the plastic tie straps to hold them in place.

7. Join the connector from the battery pack to the connec-

tor on the control panel.

8. Reassemble machine.

NOTE: Charge the batteries before using the machine.

How To Charge The Batteries

WARNING: Charging the batteries in an area with-

out adequate ventilation could result in

an explosion. To prevent an explosion,

charge the batteries only in an area with

good ventilation.

WARNING: Lead acid batteries generate gases

which could explode. Keep sparks and

ﬂ ames away from batteries. NO SMOK-

ING!

Connect the charger to a properly grounded single phase (3-

wire) wall receptacle having the voltage, frequency, and ampere

capacity speciﬁ ed on the nameplate of the charger.

Figure 5

1 2 3 4 5 6 7 8 9 10 11 12 ... 67 68

Comments to this Manuals

No comments

Clarke ultra speed Operator's Manual Page 7

Comments to this Manuals

Related products and manuals for Floor Machine Clarke ultra speed