Clarke ultra speed Operator's Manual download pdf (Page 5)

ENGLISH

Clarke

Operator's Manual (EN) - Ultra Speed

20 / 20T FORM NO. 56091104 - 5 -

PROCEDURES FOR TRANSPORTING

How To Put The Machine In A Van Or Truck

WARNING: The machine is heavy. Make sure

you use two able persons to assist

the machine in climbing the ramp.

1. Make sure the loading ramp is at least eight (8) feet

long, and strong enough to support the machine.

2. Make sure the ramp is clean and dry.

3. Put the ramp in position.

4. Turn key switch "ON".

5. Align the machine on a level surface ﬁ ve (5) feet in

front of the ramp.

6. Put the traverse knob at full speed (20T Model only).

See ﬁ gure 2 (2).

7. Push in one of the pad power switches (1). See

ﬁ gures 1 & 2.

8. Push the machine to the top of the ramp.

9. Turn the key switch "OFF".

10. Fasten the machine to the vehicle.

How To Remove The Machine From A Van Or Truck

1. Make sure there are no obstructions in the area.

2. Make sure the unloading ramp is at least eight (8) feet

long and strong enough to support the machine.

3. Make sure the ramp is clean and dry.

4. Put the ramp in position.

5. Unfasten the machine.

WARNING: The machine is heavy. Make sure you

use two able persons to assist in mov-

ing the machine down the ramp.

6. Turn the key switch "ON".

7. Ultra Speed 20T (see ﬁ gure 2) - While pushing in tra-

verse reverse switch (3), push in either the right or left

pad / traverse switch (1) at the same time.

Ultra Speed 20 (see ﬁ gure 1) - Push in either the right

or left pad power switch (1).

8. Carefully and slowly, back the machine to the top of the

ramp and start down.

9. As the machine begins to travel down the ramp main-

tain a slow downward speed.

Ultra Speed 20T Model

Figure 2

Ultra Speed 20 Model

Figure 1

1 2 3 4 5 6 7 8 9 10 ... 67 68

Comments to this Manuals

No comments

Clarke ultra speed Operator's Manual Page 5

Comments to this Manuals

Related products and manuals for Floor Machine Clarke ultra speed