Clarke SHHHAIR 50/24 Operations Instructions download pdf (Page 5)

PREPARING FOR USE

Before connecting your compressor to the mains supply, check the following:-

• Firstly, ensure the compressor is on level ground. Do not allow it to run if

it is standing on an incline.

• Check also that the mains voltage corresponds with that shown on

the data label on the side of the compressor.

• The ON/OFF switch is in the OFF

position.

• Remove any transit caps from

the air inlets and replace them

with the air inlet filters supplied.

ADDING OIL

The compressor is supplied without any

oil inside.

1. Make sure that the oil level is half

way up the oil sight glass.

2. If not, remove the oil cap and top

up the reservoir.

• Only use Clarke synthetic

compressor oil, available from

your Clarke dealer (Part No.

3050795).

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

Clarke SHHHAIR 50/24 Operations Instructions Page 5