Clarke CDP151B Instruction Manual

0205SERIAL No...

10 E. Installing the Chuck.1. Slide the table up the column and secure it to within6" of the spindle.2. Open the jaws of the chuck to their max

11Table Tilt ScaleTable SupportLocking HandleA bevel scale is provided on the table mounting, measured in degrees, to assist in setting therequired an

122. Lever the motor, on its bracket, away from the head, by turning lever B - Fig.11,anticlockwise so that tension is applied to the belts.NOTE: The

13OPERATION.1 . Insert the drill bit into the jaws of the chuck by approx 1", ensuring that the jaws donot touch the flutes of the drill. Before

14MAINTENANCEFor maximum performance, it is essential that the Drill Press is properly maintained. Alwaysinspect before use. Any damage should be repa

15CUTTING SPEEDSFactors which determine the best speed to use in any drill press operation are:1. Kind of material being worked.2. Size of hole.3. Typ

TROUBLE SHOOTINGPROBLEMA) Incorrect belt tensionB) Dry spindleC) Loose pulleyD) Worn bearingA) Adjust tensionB) Remove spindle/quill assemblyand lubri

17OPTIONAL ACCESSORIESMorticing Attachments, Mortice Chisels,Drill Press Vices, Cross Vices (Cast Iron),and Table Clampsare available from your CLARK

18HEAD ASSEMBLY

19HEAD ASSEMBLY PARTS LISTNo. Description Part No.1 Head w/pointer & trim DD133020012 Cable Clamp DD161020143 Pan Head Screw M5 30406564 Hex. Scre

2For Spare Parts and Service, please contact your nearest dealer, or CLARKEInternational, on one of the following numbers.PARTS & SERVICE TEL: 02

20PULLEY & SPINDLEASSY. No.Description Part No1 ‘V’ Belt M24 DD161050112 Pulley Nut DD133020253 Spindle Pulley DD13305009A4 Pulley Insert DD133020

21BASE ASSEMBLYPart No. Part No.CDP301B CDP351F & RE1 Column DD16101003B DD161010032 Rack DD16101010A DD161010103 Hex. Socket Screw Set 3040430 3

INTRODUCTIONThank you for purchasing your CLARKE 16mm Drill Press.Before attempting to operate the machine, please read this instruction manualthorou

GENERAL SAFETY PRECAUTIONSWARNINGAs with all machinery, there are certain hazards involved with their operationand use. Exercising respect and caution

19. DO NOT STAND ON THE MACHINE. Serious injury could occur if the machine is tippedover. Do not store materials above or near the machine such that i

ELECTRICAL CONNECTIONSConnect the mains lead to a standard, 230 Volt (50Hz) electrical supply through anapproved 13 amp BS 1363 plug, or a suitably fu

7PREPARATIONOn receipt, carefully unpack the components, ensuring that no damage was suffered intransit, and that all parts are accounted for.The foll

8Remove all traces of preservative from the components with paraffin or a good qualitysolvent, and wipe all parts thoroughly with a clean dry cloth. A

9 A. Column Assembly to BaseASSEMBLYCAUTION!ASSISTANCE MUST BE USED WHEN ASSEMBLING THIS MACHINE.Fig. 1Fig. 2NOTE: Ideally, the base should be firmly