Clarke CS6-9C Instruction Manual

BELT & DISC SANDERBELT & DISC SANDERMODEL No. CS6-9C0206OPERATING & MAINTENANCEINSTRUCTIONSPart No. 6500420

Fig. 8A shows the table being used inconjunction with the Mitre Gauge.Set the gauge to the angle you requireand hold the workpiece firmly againstthe g

Curves may be sanded as shown in Fig.9A...or the belt used in the vertical positionas shown in Fig.9B.NOTE: The work stop has been removed.DUST EXTRAC

MAINTENANCECAUTION: Before carrying out any maintenance or servicing, ALWAYS ensure theplug is disconnected from the mains supply.A. Changing the Belt

ACCESSORIESReplacement Discs and Belts are available in packs of 5 from your local dealer.Please quote the part numbers below.A. 6” Replacement Belts

1 Rubber pad HTCS69012 Side plate HTCS69023 Bolt M8x12 HTCS69034 Nut M6 HTCS69045 Washer HTCS69056 Long plate HTCS69067 Bolt HTCS69078 Short plate HTC

PARTS DIAGRAM- 15 -

- 2 -

PARTS & SERVICEPlease contact your dealer, or CLARKE International, on one of the following numbers.PARTS & SERVICE TEL: 020 8988 7400PARTS

4.ALWAYS maintain a clearance of 2mmbetween table and sanding belt or disc.5.ALWAYS hold the workpiece firmly sothat it cannot be ripped from your h

ELECTRICAL CONNECTIONSConnect the mains lead to a standard, 230 volt (50Hz) electrical supply through afused good quality 13 amp BS 1363 plug, or a su

PRE-ASSEMBLY CHECKUnpack the carton and lay out the components and loose items. Check against the listbelow to ensure that all parts are present. If a

ASSEMBLY1. Assemble the stand in the manner shown in Fig.2.The four top panels are secured with a single bolt,with flat washer, in each corner, and

With the belt raised, ensure that nothing can interferewith the disc or belt, and that the Belt Tensioning Lever(1, Fig.4), is pushed fully to the rea

B...to the BeltBefore attempting to attach the table tothe belt mounting, raise the belt arm andsecure with the two securing screws, asexplained under