Clarke CS4-6C Specifications

0607MODEL NO: CS4-6CPART No: 6500401BELT/DISC SANDERBELT/DISC SANDEROPERATION & MAINTENANCEINSTRUCTIONS

10Installing Table Assembly1. Locate table support and (3) M6 hexhead screws, flat washers andlockwashers among loose parts.2. Position table support

11Auxiliary Mounting For Vertical Sanding1. Remove backstop lock bolt and removework support.2. Remove table assembly by removing tablelock knob and w

3. Slide tension lever to the left to apply belttension.4. Tighten hex socket screw when bed is indesired position.5. Plug in the power cord. Turn swi

GETTING TO KNOW YOUR BELT/DISC SANDERWARNING: To avoid injury from accidental start, switch “OFF” and disconnect from powersource before making any a

2. Insert finger under switch lever and PULLend of switch out.3. To turn machine “OFF”... PUSH lever in.NEVER LEAVE THE MACHINE UNATTENDEDUNTIL IT CO

OPERATING INSTRUCTIONSBevel SandingWARNING: To avoid trapping the work orfingers between the table and sandingsurface, the table should be repositione

Surface Sanding On The Sanding BeltWARNING: To avoid injury from slips, jams or thrownpieces, adjust the backstop to clear the sandingsurface by no m

Always sand outside curves on the leftside of centre on the sanding disc asshown.WARNING: Applying the workpiece tothe right side of the disc could ca

MAINTENANCEWARNING: For your own safety, switch “OFF” and remove plug from power sourcebefore adjusting, maintaining, or lubricating your belt and dis

4. Slightly tighten (3) screws. Adjusttension of belt by putting bladescrewdriver in adjusting hole. Push upon screwdriver to tighten tensionbetween p

2When disposing of this product, do not dispose of with general waste. It must be disposed of according to the lawsgoverning Waste Electrical and Elec

PARTS DIAGRAM20

PARTS LIST21WARNING: The use of spare parts, other that those supplied by CLARKEInternational or one of its recognised dealers, may be hazardous and c

PARTS LIST cont.Item Description Part No2235 Table36 Support, Table37 Label, Scale38 Cord W/Plug39 Motor (1/3 HP)40 Connector, Wire41 Nut, Hex M6 x 1.

Please note that the details and specifications contained herein, are correct at the time of going to print. However,CLARKE International reserve the

Thank you for purchasing this CLARKE Belt and Disk Sander designed for hobby/DIY, indoor use, and for sanding wood or wood products ONLY.Before attem

SAFETY PRECAUTIONSWARNING: As with all machinery, there are certain hazards involved with their operationand use. Exercising respect and caution will

14. ALWAYS wear proper apparel. Loose clothing or jewellery mayget caught in moving parts. Wear protective hair covering tocontain long hair.15. ALWAY

ELECTRICAL CONNECTIONSConnect the mains lead to a standard, 230 volt (50Hz) electrical supply through afused good quality 13 amp BS 1363 plug, or a su

PRE-ASSEMBLY CHECK7Separate all parts from packing materials and check each item with the “Table ofLoose Parts.” Make certain all items are accounted

ASSEMBLY8Tools RequiredMounting To WorkbenchIf Belt and Disc Sander is to be used in a permanent location, it should be fastened securelyto a firm sup

9Clamping To WorkbenchThe belt and disc sander can beclamped directly to the board using twoor more “G” clamps on base of unit (oneclamp on each end)