Clarke 90EN Specifications download pdf (Page 13)

ELECTRICAL CONNECTIONS

WARNING! THIS APPLIANCE MUST BE EARTHED.

These welders are fitted with a standard 13 amp BS 1363 plug, fitted with a 13 amp

fuse. Connect to a 230 volt (50Hz) domestic electrical supply and we strongly

recommend that this be done via a Residual Current Device (RCD).

IMPORTANT: If the welder is fitted with a plug which is moulded onto the electric

cable (i.e. non- re-wirable) please note:

1. The plug must be thrown away if it is cut from the electric cable. There is a danger of

electric shock if it is subsequently inserted into a socket outlet.

2. Never use the plug without the fuse cover fitted.

3. Should you wish to replace a detachable fuse carrier, ensure that the correct

replacement is used (as indicated by marking or colour code). Replacement fuse

covers can be obtained from your local dealer or most electrical stockists.

Fuse Rating

The fuse in the plug must be replaced with one of the same rating (13 amps) and

this replacement must be ASTA approved to BS1362.

IMPORTANT: The wires in the mains lead are coloured in accordance with the

following code:

Green & Yellow .......... Earth

Blue .......... Neutral

Brown .......... Live

As the colours of the flexible cord of this appliance may not correspond with the

coloured markings identifying terminals in your plug, proceed as follows:

• Connect GREEN & YELLOW cord to plug terminal marked with a letter “E” or

Earth symbol “ ”, or coloured GREEN or GREEN & YELLOW.

• Connect BROWN cord to plug terminal marked letter “L” or coloured RED.

• Connect BLUE cord to plug terminal marked letter “N” or coloured BLACK.

Extension Cable

If an extension cable is fitted, ensure the minimum cross section of the conductor

is 1.5mm

for up to 15 metres in length, and 2.5mm

for up to 25 metres.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

No comments

Clarke 90EN Specifications Page 13