Clarke ENCORE S2426 Operator's Manual download pdf (Page 23)

CLARKE TECHNOLOGY Operator's Manual - Encore S2426/L2426 Page -23-

Maintenance cont.

Figure 34

Consult your Clarke Technology Authorized Service

Person to do the service procedures.

Use only genuine Clarke Technology parts.

How to Clean the Solution Line

If the solution line becomes clogged follow this

procedure:

1. Turn key switch "OFF" and remove the key.

2. Open brush motor cover and remove brush housing.

3. Remove brushes / pads.

4. Locate the solution valve. It is located behind the

brush motor.

5. Turn solution valve "OFF". See figure 34, A)

6. Locate the solution filter screen. It is located on the

back of the solution valve. See figure 34, B)

7. Unscrew the female garden hose connector from

the back of the solution valve. The filter screen is in

the female connector.

8. Remove the filter screen. See figure 34.

9. Clean and replace screen.

10. Attach the female garden hose connector to the

solution valve.

11. Turn solution valve to "ON".

How to Center or Offset the Brush Head

The brush head on the Encore 2426 can be centered

or offset 1 inch to the right side of the machine. To

center or offset the brush head, follow this procedure:

Recommended tools: 3/8" drive rachet, 3" extension

and 9/16" socket.

CAUTION: Before offsetting the brush head,

be sure that the recovery tank is

empty of solution. Follow the in-

structions on page 20 on how to

drain the recovery tank.

1. Turn the key switch "ON".

2. Raise the brush head by pressing and holding the

brush switch until the brush head is in its full up

position.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

No comments

Clarke ENCORE S2426 Operator's Manual Page 23