Clarke CAV12 Operator's Manual download pdf (Page 6)

ENGLISH

-6- Clarke

American Sanders Operator's Manual (EN) - CAV 12

TROUBLESHOOTING

ActionCause

Problem

1. Reset the fuse

2. Allow the machine to cool down approximately

5 minutes; if the machine does not start again

automatically, contact the Service Dept.

1. Replace bag-type filter.

2. Clean suction hose.

3. Clean and replace filter element.

1. Empty tank.

1. The fuse or plug socket has blown.

2. Overload protection switch has tripped.

1. Bag-type filter full.

2. Suction hose clogged.

3. Filter element clogged.

1. Tank full (float switch closing off the

suction opening).

Motor does not start.

Reduced suction power.

No suction power during

wet cleaning.

MAINTENANCE AND REPAIR

CAUTION: Before cleaning and servicing the

machine, always remove the power cord.

Carry out only maintenance operations described in

these operating instructions. Use only original Clarke

service parts.

CAUTION: Do not make any technical

modifications to the machine. Your safety

could be endangered as a result!

For all other maintenance and repair work,

please contact and authorized service

department.

Replacing The Filter Element

1. Switch off the machine and pull the plug of the

power cord out of the plug socket.

2. Remove the machine top section from the dirt tank

and place to one side with the filter element facing

upwards (Figure 5).

3. Unscrew the filter retaining nut (1) and remove

together with the retaining washer (2).

4. Pull off the filter element (3).

5. Push on a new filter element.

6. Fit the filter retaining washer and tighten the

retaining nut.

7. Dispose of the used filter element in accordance

with the local waste disposal regulations.

Figure 5

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Clarke CAV12 Operator's Manual Page 6

Comments to this Manuals

Related products and manuals for Vacuum cleaners Clarke CAV12