Clarke CON300 Specifications Page 1

1VARIABLE SPEEDJIG SAWOPERATING & MAINTENANCEINSTRUCTIONSLS0610Part No. 6460200ELECTRIC SANDERMODEL No. CON300Part No. 6462052ELECTRIC SANDER

10MAINTENANCEWARNING!Make sure that the sander is switched off and disconnected from themains supply before starting any cleaning or maintenance proce

11PARTS DIAGRAM

12PARTS LISTmetI rebmuNtraP noitpircseD ytQsaelbaliavAtraperapSametI rebmuNtraP noitpircseD ytQsaelbaliavAtraperapSa1202061PKdaeLsniaM1seY42820413PKna

13DECLARATION OF CONFORMITYWhen disposing of this product, ensure it is disposed of according to alllocal ordinances. It must not be disposed of with

14VIBRATION EMISSIONSEmployers are advised to refer to the HSE publication “Guide for Employers”.All hand held power tools vibrate to some extent, and

15Declared vibration emission value in accordance with EN12096Measured vibration emission value - a:< 2.5 m/s2Values determined according to EN2862

16

2

3Thank you for purchasing this CLARKE Sander.Before attempting to use the sander, please read this manual thoroughly andfollow the instructions carefu

4SAFETY PRECAUTIONSWARNING!As with all machinery, there are certain hazards involved with theiroperation and use. Exercising respect and caution will

515. ALWAYS use recommended accessories. The use of improper accessoriescould be hazardous.16. ALWAYS remove plug from electrical outlet when adjustin

ELECTRICAL CONNECTIONSThis product is provided with a standard 13 amp, 230 volt (50Hz), BS 1363 plug, forconnection to a standard, domestic electrical

PREPARATIONWARNING!Disconnect the plug from the power source before fitting/changing thesandpaper.FITTING THE SANDPAPERTo fit the sandpaper, proceed a

8OPERATION1. Connect the plug to the mains supply socket and switch on.2. Hold the sander firmly with both hands.OPERATING THE TRIGGER SWITCHWARNING!

9DustExtractionPortFig 4Fig 5OPERATIONUSING THE SANDER1. Make sure that there are no nails or other objects in the area to be sanded.2. Let the sander