Clarke ALTO C2K Series Operator's Manual download pdf (Page 22)

Page -22 - Clarke

Operator's Manual- C2K Series 120V

Figure 5

HOW TO OPERATE THE MACHINE

How To Start/Stop The Machine

WARNING: Never start a polisher when

the handle is in the vertical

position.

The following step applies to the C2K-1600DS and C2K-

2000DS only:Select high or low speed with the switch

located on the motor cover. Moving the switch lever up

selects high speed. Moving the switch lever down

selects low speed.

The following steps apply to all C2K series:

The switch to start and stop the machine is activated

by the interlock switch (1) and the levers (2) under the

handle grips. See figure 5.

To start the machine, follow this procedure:

1. Lower the handle

2. Lock the handle in the best position for operation.

NOTE: Make sure you hold the handle with both

hands.

3. Push the interlock switch (1), and apply pressure to

the levers (2). See figure 5.

How To Control The Machine

NOTE: Make sure you hold the handle with both

hands.

The side to side movement of the machine is controlled

by raising the handle and pressing down on the handle.

To move the machine to the left, press down on the

handle slightly. To move the machine to the right, raise

the handle slightly.

MAINTENANCE

WARNING: Maintenance must be done

by authorized personnel

only.

Maintenance Instructions

Return the machine to a Clarke Authorized Service

Location every 12 months for maintenance inspections.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

No comments

Clarke ALTO C2K Series Operator's Manual Page 22