Clarke CPT600 Specifications download pdf (Page 8)

1. Attaching the Angle Fence

The peg - ‘A’ locates in the slotted

hole - ‘B’. It may be necessary to screw

the peg down a little in order for the

peg to locate properly.

The Hex. socket head screw with

washers (in the bag of loose parts), is

used to secure the fence to the table,

through slot ‘C’, into threaded hole ‘D’.

The fence may be set and locked at

any angle. Use a template or angle

gauge if accuracy is required.

2. Attach the Dust/Chip Extraction Chute

A. For Planing

A.1 Lower the Thicknesser Table as far as

possible by turning the Raise/Lower Knob

(see Fig.1) fully anticlockwise.

Fig. 3

Fig. 4

A.2 Pull out the two Locking Keys (arrowed in

Fig.4) and manouvre the Chute into the

space beneath the table.

Ensure both Locking keys are pushed firmly

into the slots in the table, shown in Fig.5.

Fig. 5

B. For Thicknessing

B.1 Remove the Angle Fence.

B.2 Push the Cutter Guard out of its

holder so that the Chute may be

attached to the table, as shown

in Fig.6.

Ensure both Locking keys are pushed

firmly into the slots in the table, shown

in Fig.5.

Fig. 6

IMPORTANT: Please note that the Dust Chute MUST ALWAYS be in place, the machine

will not operate if is removed.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

No comments

Clarke CPT600 Specifications Page 8