Clarke CAT101 Specifications download pdf (Page 9)

MAINTENANCE

WARNING! Make sure that the impact wrench is disconnected from the air supply before

starting any cleaning, or maintenance procedures.

Daily

• Drain water from air tank, air line and compressor.

• Pour a few drops of CLARKE Air Line Oil, into the air inlet. This should be carried out

regardless of whether or not an air line lubricator is used. If an Air line lubricator is not

used, this procedure should be repeated after every two to three hours of use.

Weekly

• Check the air inlet screen filter and clean if necessary.

• Remove the grub screw and insert a few drops of oil into the oil port on the side of

the impact wrench.

CLEANING

• Keep the body of the impact wrench clean and free from debris, Grit or gum

deposits in the tool may reduce efficiency.

SERVICE AND REPAIR

• All servicing and repair must be carried out by qualified service technicians.

NOTES

Please note that factors other than the tool may effect its operation and efficiency such

as reduced compressor output, excessive drain on the airline, moisture or restrictions in

the line, or the use of connectors of improper size or poor condition which will reduce air

supply.

**Clarke Air Line Oil is available from your CLARKE dealer part no. 3050825.

We declare that these products comply to the following standards/directives

• 98/37/EC

Model No: CAT101

Serial or Batch number: See product data plate

signature:

D. Kemp

ENGINEERING MANAGER

DECLARATION OF CONFORMITY

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Clarke CAT101 Specifications Page 9